Adlink Express-HLE Manual do Utilizador descarregar pdf (Página 84)

Page 84 Express-HLE

Step 4: Use the four M2.5, L=6mm screws provided to fasten the heatsink to the module.

Step 5: Place the COM Express module and heatsink assembly onto the connectors on the carrier board as shown.

Then press down on the module until it is firmly seated on the carrier board.

Step 6: Use the five M2.5, L=16mm screws provided to secure the COM Express module to the carrier board from the solder side.

Step 7: If you are installing a heatsink with a fan, plug the fan connector into the carrier board as shown.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89

Express-HLE 1
Revision History 2
Preface 3
Table of Contents 4
Express-HLE Page 5 5
1 Introduction 6
2 Specifications 7
2.10 Power Specifications 9
2.11 Operating Temperatures 9
2.12 Environmental 9
2.14 Operating Systems 9
Mobile Intel® 10
QM87/HM86 10
2.16 Mechanical Drawing 11
3.1 AB / CD Pin Definitions 12
Express-HLE Page 13 13
3.3 AB Signal Descriptions 16
3.3.3 LVDS 17
3.3.4 Gigabit Ethernet 17
3.3.5 Serial ATA 18
3.3.6 PCI Express 19
3.3.7 Express Card 19
3.3.8 LPC Bus 19
3.3.9 USB 20
3.3.11 SPI (BIOS only) 22
3.3.12 Miscellaneous 22
3.3.13 SMBus 22
3.3.14 I2C Bus 23
3.3.18 Power and Ground 24
3.4 CD Signal Descriptions 25
3.4.3 DDI Channels 26
Page 28 Express-HLE 28
Express-HLE Page 29 29
3.4.7 Power and Ground 30
4.1 40-pin Debug Connector 32
4.2 Status LEDs 34
4.3 XDP Debug header 35
4.4 Fan Connector 36
4.6.1 Switch Locations 37
5.1.1 Voltages 41
5.1.2 Main Current 41
5.1.3 BMC Status 41
5.1.4 Exception Codes 42
5.1.5 BMC Flags 42
6 System Resources 43
6.3 I/O Map 44
Express-HLE Page 45 45
I/O Map (cont'd) 45
Express-HLE Page 47 47
APIC Mode (cont'd) 47
Page 48 Express-HLE 48
6.7 SMBus Slave Addresses 49
7 BIOS Setup 50
7.2 Main 51
7.2.4 System Management 52
7.2.5 System Date and Time 55
7.3 Advanced 56
7.3.2 Memory 57
7.3.3 Graphics 58
7.3.4 SATA 59
Page 60 Express-HLE 60
7.3.5 USB 61
7.3.6 Network 62
7.3.7 PCI and PCIe 63
Page 64 Express-HLE 64
7.3.8 Super IO 66
Express-HLE Page 67 67
7.3.10 Sound 68
7.3.11 Serial Port Console 68
7.3.12 Clock 69
7.3.13 Thermal 70
7.3.14 Miscellaneous 70
Express-HLE Page 71 71
7.4 Boot 72
7.5 Security 73
7.6 Save & Exit 73
8.1 Status Code Ranges 75
8.2 Standard Status Codes 75
8.2.2 SEC Beep Codes 76
8.2.3 PEI Status Codes 76
Express-HLE Page 77 77
8.2.4 PEI Beep Codes 78
8.2.5 DXE Status Codes 78
Express-HLE Page 79 79
8.2.6 DXE Beep Codes 80
8.2.7 ACPI/ASL Checkpoint 81
9 Mechanical Information 82
9.2 Thermal Solution 83
9.3 Mounting Methods 85
9.4 Standoff Types 86
Safety Instructions 87
Getting Service 88

Comentários a estes Manuais

Sem comentários

Adlink Express-HLE Manual do Utilizador Página 84

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware Adlink Express-HLE